642-832 Q&A – New Choice Questions

By | February 25, 2012

QUESTION NO: 1
%LINK-3-UPDOWN: Interface Serial0/0,
%LINKPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/14, changed state to up.
Refer to the graphic shown above. What statement is correct regarding the output shown in the graphic?
A.    The first log message is an error message with a severity level of 3.
B.    These two log messages will not have a severity level. They are not errors but are just informational messages.
C.    The first log message is categorized as warning message.
D.    These messages regarding interface status are normal output and will always be displayed when you exit config mode.
E.    The second message would be shown if the logging console warning command had been issued.

Answer: A

QUESTION NO: 2
Two Cisco routers are connected to each other and are enabled CDP. Serial line is up, protocol is also up, but cdp neighbor not working. What layer of the OSI model does the problem most likely exist?
A. Physical
B. Session
C. Application
D. Data-Link
E. Network
Answer: D

QUESTION NO: 3
Which three management categories are contained in the FCAPS network maintenance model?(choose three)
A. accounting
B. telecommunications
C. config
D. fault
E. storage
F. redundancy
Answer: ACD

QUESTION NO: 4
A technician is troubleshooting connectivity problems between two routers are directly connected through a serial line. The show CDP interface command shows that serial line is up and CDP has been enable. the technician cannot see any neighbors in the output of the show cdp neighbors command. In which OSI layer is the problem most likely occur?
A. network
B. data link
C. application
D. physical
E. transport
Answer: B

QUESTION NO: 5
What is the result of configuring the logging console warning command?
A. warning, critical, alert, and emergency messages will be logged on console
B. messages with a severity level of 4 and higher will be logged to all available TTY lines
C. warning, error, critical, and informational messages will be logged on the console
D. the logging console warning command needs to be followed in the configuration with logging buffered but size to …size for the console
E. only warning messages will be logged on the console
Answer: B

QUESTION NO: 6
Which two of the following options are categories of Network Maintenance tasks?
A. Firefighting
B. Interrupt-driven
C. Policy-based
D. Structured
E. Foundational
Answer: B, D

QUESTION NO: 7
You are configuring two routers as NTP server, what will most likely happen?
A. The router will choose the best reliable server and will synchronize with it.
B. Pending
C. Pending
D. Pending
Answer: A